Weld-On Drawbar Eye With Diameter 2-3/8 Inch

* High Quality Weld-On Drawbar Eye
* Inside Diameter 2-3/8 Inch
* 35 Degree V Angle
* Weld Tabs Can Be Heated And Bent Plus/Minus 10 Degrees To Accommodate Installation Requirements
* Max Gross Trailer Weight 100000 Lbs
* Max Tongue Weight 15000 Lbs
* Slack Reducing Drawbar Eyes Must Be Used With An Air Service Chamber Or No. 500 Slack Adjuster
* Clean And Inspect Drawbar Eyes And Eye Assemblies For Damage Or Excessive Wear Before Each And Every Use
* Do Not Apply Lubricants To The Drawbar Eye Loop
* Structure To Which Eye Is Attached Must Be Of Sufficient Strength To Withstand Load Rating Of Eye
* Do Not Bind-Up Jackknife Any Application As Stresses Can Cause Damage To Products Or Components Resulting In Failure And Detachment Of The Trailer While In Use
* Made In USA
* Sold As Pair
* Warranty On Weld-On Drawbar Eyes Against Defects In Workmanship & Material From Date Of Purchase

*** High Quality Aftermarket Replacement Part (Not OEM)***

** This Item Ships Direct From The Manufacturer And Will Arrive In A Separate Package And Possibly A Different Time Than The Balance Of Your Order **